Deck Dock Skateboard Wall Mount System - 2 Pack

Product Information

Don't tie it too close to the holes in the deck, but instead provide a little slack between the knot and the deck to make hanging it easier. Loop the knots you tied in step one onto the command hooks to stretch the rope between the two hooks. In that case, simply slide the double fisherman knot up the rope to shorten the rope and keep the skateboard snug to the hook. Since you need enough rope to go the length of your skateboard deck, this time you’ll need a little more length. One simple way is to hang it up on your wall with some fishing line until you're ready to take it down and use it.

Hold the display against the wall and line up the hole at the center with the hole you drilled in the wall.A double fisherman can slide up or down after it’s tied so it’s easy to adjust the length of the line once you’re done. Then, insert a plastic wall anchor into the hole to ensure that it effectively holds the weight of the deck. Ideally, the second bolt hole you go through is on the bottom side of your deck when it’s in the mounted position. There are a number of ways to mount your skateboard to the wall, with or without nails, but as someone who’s a renter, opting for no-hole options is pretty much my only option. Custom-built products are not eligible for a refund unless we deem there to be a manufacturer defect, this includes products where you have selected the option to "Build my Board" or "Apply Grip T ape".

Use a ruler or measuring tape to measure about 25 inches (64 cm) and use a sharp knife to cut the rope at this point. Going from a similar technique as the last mounting option, this method requires some slightly different knot tying to get the job done. Once again, be sure you are using command hooks rated for at least 5lbs for standard skateboard decks. We strongly recommend using a 'signed-for service' with the Royal Mail, Parcel Force or a Courier Service. This line will be threaded through the skateboard so the shorter the line, the closer to the hook your deck will mount.Securely repackage your item with the appropriate amount of padding, we recommend reusing the packaging it arrived in.

Here at the Shred Tactic, our goal is to be the ultimate resource for skateboarding, with articles written by skaters for skaters.If you have a deck with horizontal graphics, mounting the board to your wall horizontally may be the better way to go. This means each wall mount will be unique, carrying the history and battle scars from its former life! Taking the end of your rope to the other side of your deck, poke it through the closest bolt hole, then thread diagonally to the bottom bolt hole as shown below. If you’ve already removed your trucks, hang your skateboard deck on the wall by cutting a 1 foot piece of fishing line.